Remote-processing RPC-330 Bedienungsanleitung PDF herunterladen (Seite 7)

SETUP AND OPERATION SECTION 2

Page 2-1 RPC-330

Figure 2-1 Connector location and function

INTRODUCTION

The RPC -330 is ready to program as soon as you

connect it to a ter minal or PC and apply pow er. This

section describes what is needed to get a sign- on

message and begin programming.

Requirements for uploading and downloading programs

are discussed. A "W here to go from here" section tells

you what sections to refer to in order to use the various

capabilities of the RPC-330. Finally, a troubleshooting

section helps out on the most common problems.

OPERATING PRECAUTIONS

The RPC -330 is designed to handle a wide variety of

temperature ranges at low power. These characteristics

require using CM OS com ponents. CM OS is static

sensitive. To avoid damaging these components,

observe the following precautions before handling the

RPC-330.

1. Ground yourself before handling the RPC -330

or plugging in cables. Static electricity

can easily arc through cables and to the card.

Simply touching your PC before you touch the

card can greatly reduce the amount of static.

2. Do not insert or remove components when

power is applied. While the ca rd is a + 5 volt

only system, other voltages generated on the

card which affect other components.

EQUIPMENT

You will need the following equipment to begin using the

RPC-330:

RPC-330 embedded controller

PC with a serial port and com munications

program

or a

Terminal

VTC -9F ser ial cable

+ 5, 300 ma power supply

Refer to SECTION 4, SERIAL PORTS, for wiring

information to make your own serial cable.

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Keine Kommentare

Remote-processing RPC-330 Bedienungsanleitung Seite 7