Remote-processing RPC-210 Bedienungsanleitung PDF herunterladen (Seite 59)

TECHNICAL SPECIFICATIONS SECTION 16

Page 16-2

between the battery and IC under it to keep the battery

from rocking. Bear in mind that the clock and RAM

draw micro-amps of current. Any conduction between

the + and - sides of the battery drains it. Be careful of

chemical adhesives as they may initially draw a lot of

current unit they cure.

Another way ar ound the batter y problem may be to

remove B1 and solder leads to the battery holes.

Secure the settings for the reference and contrast pots R7

and R16. These pots are relatively open, so a high

viscosity fluid should be used.

MOUNTING TO A MOTHER BOARD

The RPC-210 can plug into a "mother board" which has

power, signal and other functions on it. F igure 15-1

shows pin 1 connector locations. Mother board

connectors are dual row, female, on a 0. 1" x 0.1"

matrix, for 0.025" square posts. A table of

manufacturers and types are listed below.

Manufacturer P/N and size

3M 929852E-01-26 26 position

3M 929852E-01-20 20 position

3M 929852E-01-10 10 position

AMP 2-1734508 26 position

Oupiin 204-126GS PCB mount, 26 pin

Oupiin 204-120GS PCB mount, 20 pin

Oupiin 204-110GS PCB mount, 10 pin

Samtec SSM series (surface mount)

Samtec SSW, SSQ series (through hole)

Samtec ESW, ESQ series (elevated)

Samtec connectors come in a variety of plating and

lengths. Contact them at 800-726-8329 for more

information.

Maximum component height is 0.60".

Remote Processing can, on special order and in quantity,

put connectors on the circuit side of the board.

1 2 ... 54 55 56 57 58 59 60

Keine Kommentare

Remote-processing RPC-210 Bedienungsanleitung Seite 59